The MB 36 is a Myler alternative to the traditional mullen, but it has a wide low port that allows the tongue to pass under it comfortably. The port is 1" high, and tilted forward at a 45º angle, allowing just enough room for the horse’s tongue to elevate slightly and swallow, but not high enough for palate pressure. When the reins are engaged, the MB 36 applies pressure primarily to the bars and lip, but also applies tongue pressure because of the forward tilt. Sweet iron mouthpiece oxidizes and encourages salivation.

• Independent Side Movement
• Sweet Iron mouthpiece
• Curved mouthpiece does not pinch lips or bars
• Copper Inlay

Notes: This mouthpiece is a step up in tongue relief from Level 2, but because the port is low, it does not offer as much tongue relief as other Level 2-3 mouthpieces with slightly higher ports because the tongue is still somewhat restricted. The MB 36 mouthpiece is similar to the MB 06, except that it is ¼" higher and the port is tilted forward. The MB 06 mouthpiece will apply less tongue pressure than the MB 36 but additionally offer less tongue relief when the reins are relaxed. For more overall tongue relief and less tongue pressure, see the 43LP. The 6" stainless steel 3-ring combination bit is a hybrid of a ring bit, shank bit, and hackamore and uses five different pressure points to disperse rein pressure. Because the noseband and chin strap are connected through the purchase, when the reins are engaged, the horse first feels nose, chin and poll pressure before he feels the mouthpiece. The mouthpiece can slide 1" before reaching a stop, where it will then engage and apply pressure. The purpose is to give the horse an opportunity to respond to the rider’s rein signals before applying mouthpiece pressure. The combination bit has Independent Swivel Cheek and the purchase is slightly angled away from the cheek to prevent rubbing. The noseband is flat leather with knotted cord on either side and the chin strap is synthetic to avoid stretching over time.